Conditions of use of CNC lathe

The normal use of CNC lathe must meet the following conditions, the machine is located in the location of the power supply voltage fluctuation is small, the ambient temperature is less than 30 degrees Celsius, the relative temperature is less than 80%.

Karnley appearance

Environmental requirements

The location of the machine bed should be far away from the vibration source, should avoid the influence of direct sunlight and thermal radiation, avoid the influence of humidity and air flow. If there is a vibration source near the machine bed, the machine bed should be surrounded with anti-vibration grooves. Otherwise, it will directly affect the processing accuracy and stability of the machine, and will make the electronic components contact poorly and malfunction, affecting the reliability of the machine.

CK6125 tool arranging machine (X-axis stroke 620mm Z-axis stroke 200mm (∠30 tool arranging machine 25 machine inclined bed (high configuration))

Power requirements

A general digital control lathe installed in the machining workshop, not only the ambient temperature changes, the use of poor conditions, and a variety of mechanical and electrical equipment, resulting in large fluctuations in the electrical network. Therefore, the location of the installation of digital lathes, the need for strict control of the power supply voltage. Power supply voltage fluctuations must be within the allowable range, and maintain a relatively stable. Otherwise, it will affect the normal operation of the digital control system.

CKX6152D-Y turret with Y-axis turning and milling machine (4 ends and 4 sides with Y-axis with turret)

Temperature conditions

The ambient temperature of the digital control lathe is less than 30 degrees Celsius, and the relative temperature is less than 80%. Generally speaking, the digital control box is equipped with internal exhaust fans or coolers to keep the electronic components, especially the central processing unit working temperature constant or very small temperature difference changes. Excessive temperature and humidity will lead to a reduction in the life of the control system components, and lead to increased failure. Increased temperature and humidity and increased dust can cause adhesion on the integrated circuit board and lead to short circuits.

CKX6146D Standard 46 turret machine (45 degree slant bed line gauge machine)

Regulation of machine tool use

When using the machine, the user is not allowed to arbitrarily change the parameters set by the manufacturer in the control system. The setting of these parameters is directly related to the dynamic characteristics of the machine components. Only the value of the gap compensation parameter can be adjusted according to the actual situation.

The user is not allowed to change machine accessories, such as hydraulic chucks that are not specified in the instruction manual. When setting the accessories, the manufacturer takes into full consideration the matching of the parameters of each link. Blind replacement causes mismatch of parameters of each link, and even causes unexpected accidents.

CK6136B∠45 slant bed height configuration table (36 standard slant bed tool arranging machine)

The pressure of using hydraulic chuck, hydraulic tool holder, hydraulic tailstock and hydraulic cylinder should be within the permitted stress range and not allowed to be raised arbitrarily.